Description

Description of toilet paper holder

• Toilet paper holder is of standard design to fit all sizes of towel papers.
• This holder is design to withstand light to heavy paper quality with ease.
• This toilet paper holder is convenient to use, hygienic, efficient, and durable.

• To make life easier, safer, and more organized.
• We are showing you how to install our toilet paper holder and phone shelf.
• There are some tools needed to make this installation simple.
• A pencil, screwdriver, drill, quarter-inch drill bit or smaller, stud finder, tape measure, and a level.
• If you have the old toilet paper holder try to remove it.
• It is better to locate a place in the wall to screw into for your first hole.
• You need to find the exact point in the wall and draw a line.
• Where you want to place the holder on the wall.
• If the spacing is too far apart, better to use bolt drywall anchors.

usage and fittings

• If you are unsure how high to mount the toilet paper holder.
• Its better to place about 28 inches from the floor.
• You can reuse one from our old holder and place it in the new holder.
• If it does not work hold buy a new holder for the wall and use your pencil to mark your first hole.
• The hold should not be longer than the quarter-inch on your mark.
• Insert a drywall anchor into the wall.
• Fit very By using the drill, screw the shelf onto the wall.
• We found the bit extension helpful as our shelf has very little clearance underneath.
• Use a hand screwdriver to pick up the screw.
• Level out the shelf and mark your second hole with a pencil.
• Loosen it just a bit so that it can be tight to the wall.
• Be careful that there should not be any scratches on the wall.
• Now you can drill your second hole.
• Insert the drywall anchor.
• Screw the shelf to the wall and tighten it by hand.
• Until the shelf is secure and tight.
• You should be careful not to over-tighten as it could strip out the toilet paper holder.
• Install any decorative screw caps that were included in the holder.
• It may fit snugly due to the low clearance under the shelf.
• The modern style holders have a three-part screw attachment.
• There is a screw, a threaded washer, and a screwcap.

Installation

• Sometimes the washer gets stuck inside the cap during the packaging.
• You should unscrew it with your finger or a pencil eraser.
• Place the screw through the washer and attach the holder’s arm.
• With our modern-style holders, the arm installs from the top.
• Our vintage designs screw from the bottom.
• Any direction that you need.
• Be sure that the arm is securely fastened and won’t loose.
• Finish it off with the screw cap.

After fitting you now can enjoy the new toilet paper holder and phone shelf.

Follow us on Facebook and Instagram. Click on it.